Megger PAT350 PAT Tester - Megger PAT300 Series

Click images to enlarge

The new Megger PAT350 PAT Tester is one of two new Portable Appliance Testers from Meggers PAT 300 range.

This portable PAT Tester is ideal for testing all electrical equipment to meet Health and Safety regulations. The Megger PAT350 PAT Tester is a fully featured tester with dedicated test buttons for direct access to tests.

The Megger PAT350 can test a full range of electrical items including Class I, Class II, IEC Power Leads, Extension Leads and full tests for portable RCDs. It also has the ability to carry out Flash Tests. An automatic mode is available for Class I and Class II testing. In automatic mode, the tests proceed sequentially through bond, insulation and operation, indicating a pass or fail at each test.

If a fail occurs, the Megger PAT350 stops testing. When manual testing, each test is preceded by a selection screen where the test parameters are selected, such as bond test current, insulation test voltage or leakage test type. These diagnostic buttons provide direct access to any test individually, allowing single tests to be performed following repair or a suspect result.

Megger PAT350 PAT Tester key features:
• Flash test
• Simple manual or automatic testing
• 230 V and 110 V operation
• Bond testing at 25 A,10 A and 200 mA
• Differential, touch and substitute leakage testing
• Full colour display
• Tests portable RCDs and extension leads

Megger PAT350 comes supplied with:
• Megger PAT350 PAT Tester
• Megger PAT350 carry case
• Flash test probe
• Combined earth-bond and insulation test lead
• Adaptor for testing extension leads

Also available in this range is the Megger PAT320. This has all of the same features of the PAT350 only without the added capability of Flash Test.

Calibration Certificate is NOT included - We recommend adding a Calibration Certificate to your Megger PAT320 PAT Tester as your evidence of accurate portable appliance testing.